The independent comparison of mobile, internet and TV plans in Switzerland.
The question is settled in three steps, and the first doesn't depend on you: what reaches your home. Fibre, cable, copper or nothing at all — the address decides before the budget does.
Next comes the speed you will actually use, almost always lower than you think. Only then the price, once you have taken out the fees that are not on the label.
Our comparator tracks 58 offers, from around twenty francs to eighty. The gap rarely comes down to connection quality: it comes down to the speed sold, the minimum contract term, and what the provider charges on top of the monthly fee.
Four technologies coexist in Switzerland, and they are not equal.
Fibre is the only one that keeps its promise in both directions. It dominates the catalogue — forty-six offers out of fifty-eight — and it is the only one that goes up to 10 Gbit/s. Its real strength is not the maximum speed but symmetry: as much upload as download. You won't notice it watching a video; you will notice it in video calls, online backups, and as soon as several people work from home.
Cable uses the television coaxial network. It downloads fast and uploads much less — upload tops out far below download. And capacity is shared with the neighbourhood, which shows at peak times.
DSL runs over the copper telephone line. Its speed depends on the distance to the exchange: two homes on the same street can get very different results. It remains the only option in part of the country.
Wireless — fixed internet over 5G — is installed without a technician and without works. It is the answer for a poorly served home, frequent moves or a temporary need. The trade-off is higher latency and sensitivity to load on the local mobile network.
Most people pay for a speed they will never reach, because they add up uses that rarely overlap.
A few benchmarks. HD video streaming needs about 5 Mbit/s per stream, 25 in 4K. A video call runs at around 3 to 5 Mbit/s. Browsing, messaging and music are counted in single figures.
A household of four people each watching a 4K video at the same time — a rare case — uses about a hundred megabits. One hundred megabits per second is therefore enough for the vast majority of households, and our catalogue offers ten plans at that tier.
Above that, the gain becomes hard to notice. Going from 1 to 10 Gbit/s doesn't make pages load faster: at these speeds, it is the servers at the other end and the wifi in your home that set the limit, not your subscription. Very high speed is justified for transferring large files regularly, not for browsing.
Three cases justify going higher: remote work with large uploads, a home where several people create content, and systematic cloud storage.
A 1 Gbit/s subscription doesn't give 1 Gbit/s on your laptop. It isn't a con: the figure describes what reaches the socket, not what reaches the device.
Wifi is the main bottleneck. Between the router and a device two walls away, losing half the speed is common, sometimes more. An Ethernet cable gives the real figure; wifi gives what the home lets through.
Hardware counts too. A computer whose network card tops out at 1 Gbit/s won't exceed 1 Gbit/s, whatever the subscription. On 10 Gbit/s offers you need equipment built for it, or you pay for a speed nothing in the home can receive.
Always measure over a cable before concluding that your subscription is to blame. Nine times out of ten, the subscription has nothing to do with it.
This is where the real gap opens between two offers that look similar.
Activation fees range from zero to more than a hundred francs depending on the provider and the technology. They are often waived during a promotion — and reappear afterwards.
Modem or router rental is sometimes included, sometimes charged every month. Over twenty-four months, a surcharge of a few francs weighs more than a two-franc difference in the monthly price.
The connection. If fibre has not yet been run to your home, installation may be charged, and it requires the landlord's consent.
The landline is included in some offers and sold separately in others. If you have no use for it, an offer that includes it is not a good deal for that reason.
On this specific point, the only reliable method is to calculate the total cost over the minimum contract term, fees included, rather than comparing monthly prices.
The two formulas look alike on the product page and have nothing in common on the bill.
A lifetime discount stays in place as long as the subscription is active. It only ends if you cancel or change plan.
A 24-month promotion takes you back to the catalogue price in the twenty-fifth month. The gap is rarely trivial: in this market, a promotional price can be half the normal price, and the return happens all at once, without a reminder.
Our comparator shows the catalogue price struck through next to the promotional price, with the type of discount. When an offer shows a "no minimum term" price next to a "with minimum term" price, it is not counted as a promotion: it isn't a discount, it is two different products.
The full mechanism is detailed in our guide to reading a telecom offer.
As with mobile, the brand and the infrastructure are two different things — but the split is different.
Swisscom carries the largest number of offers in the catalogue, under its own name and under several brands that rent its network. Sunrise comes next, with its own cable network inherited from the former UPC as well as fibre. Salt offers fibre where it is available.
Two categories are worth knowing. Regional providers — thirteen offers in our catalogue — run their own network over a limited area: they are not available everywhere, but where they are, their prices and customer service often stand up to comparison. And Init7, which holds a special place: an independent operator, focused on very high symmetrical speeds and net neutrality.
Each row of the comparator shows the host network. It is the information that tells you two offers at very different prices go through the same cable.
This is the peculiarity of fixed internet, and it upsets many comparisons: an offer only exists if it serves your home.
Fibre arrives street by street, building by building. Two neighbours in the same area can have completely different options. Cable follows the old television network, with its own map. DSL is the most widespread, and the most uneven.
Check availability at your address before comparing prices: it often eliminates half the offers, and the comparison that remains is the real one. We provide a network coverage page by address for this first sort.
A point tenants often miss: connecting a building to fibre, when it isn't yet connected, is the building owner's decision. It isn't a permanent obstacle, but it is a delay.
Switching goes smoothly under three conditions, and the order matters.
First check your notice period. In this market, internet contracts are often cancelled with several weeks' notice, and a twenty-four-month minimum term runs to its end. Cancelling before checking risks double billing or a cut-off.
Let the new provider organise the switch. Most offer to handle the cancellation with the old one and synchronise the dates. It is the only way to avoid days without a connection.
If you are keeping a landline number, say so when ordering: keeping it is possible, but it must be requested at the time of the switch, not afterwards.
Keep the old equipment until you have confirmation that the new one works. A modem returned too early gets charged.
The default ranking is ascending monthly price, with no weighting. At equal prices, offers are sorted alphabetically. No offer is moved up in exchange for payment. When a link earns us money, it carries the 🤝 Partner badge, and that changes nothing about its place in the ranking.
Four filters are available on this page, and only four: host network, technology — fibre, cable, DSL, wireless —, speed and maximum price. We don't offer a filter that wouldn't really act on the list.
Prices are collected automatically from the providers' official product pages, with a tool that loads the page the way a browser would — which means it can also read prices displayed by JavaScript. Each offer shows the date it was last checked, and the history is kept: you can see whether a price has gone up or down since we started tracking it.
An offer whose promotion has expired leaves the comparator rather than staying on at a price that no longer exists.
Understand before you sign
The 2 guides for this page.
Swisscom, Wingo (which uses Swisscom's infrastructure), Init7 Fiber7 and iWay (on its four tiers, from 20 Mbit/s to 10 Gbit/s) officially allow you to use your own router (Fritz!Box, MikroTik, UniFi, pfSense, etc.) — either as a direct replacement or on a separate subnet behind the provider's box.
At Swisscom, the configuration is officially documented (DHCP option 60 with value 100008,0001, VLAN ID 10 for fibre, IGMP multicast proxy to be enabled for blue TV). Sources: swisscom.ch → external router and swisscom.ch → network interfaces.
⚠️ Restrictions to be aware of:
• On 10 Gbit/s fibre (XGS-PON) at Swisscom/Wingo/blue Internet L: only routers and modules certified by Swisscom are supported.
• Init7 Easy7 requires the exclusive use of the Init7 modem (preconfigured FRITZ!Box) — a « turnkey » positioning. To use your own hardware with Init7, choose Fiber7 (« free choice of router »).
• For Sunrise, Salt, yallo and the regional cable operators (Netplus, Quickline), the policy varies and is not always publicly documented — ask the provider directly.
This freedom is especially sought after by technical users — it is flagged by the 🔧 « Own router allowed » badge on the relevant offers in this comparison.